22
1
: Set the reader in programming mode, see page: 15
2
: Present the “Configuration Card” to the reader as shown. Keep the card within read-
ing distance until the reader beeps and blinks in green. The reader is now programmed
and ready for use according to the configuration settings on the configuration card.
Note:
Configuration Cards can be programmed to a pre-initialized Configuration Card
using the reader tool software and a LenelS2 Readers - 5000 series Reader
connected to the reader tool using a RS485 to USB converter.
• Reader tool software and connection cable set, part no. LNL-R50000-TOOL,
LNL-R50000-TOOL-UK or LNL-R50000-TOOL-US
• Pre-initialized configuration card, part no. LNL-C5000-PCC
Configuring the reader
Configuration Card, part no: LNL-C5000-PCC
16
1
: Set the reader in programming mode, see page: 15
2
: Present the “Configuration Card” to the reader as shown. Keep the card within
reading distance until the reader beeps and blinks in green. The reader is now
programmed and ready for use according to the configuration settings on the
configuration card.
Note:
Configuration Cards can be programmed to a pre-initialized Configuration
Card using the reader tool software and a Lenel Readers - 5000 series Reader
connected to the reader tool using a RS485 to USB converter.
• Reader tool software and connection cable set, part no. LNL-R50000-TOOL,
LNL-R50000-TOOL-UK or LNL-R50000-TOOL-US
• Pre-initialized configuration card, part no. LNL-C5000-PCC
Configuring the reader
Configuration Card, part no: LNL-C5000-PCC
BEEP !
Reading distance
approximately 2 cm.
