LENCO NAV-600, Руководство по эксплуатации, Страница: 9 / 14

1
2
1. Plug the jack (1) of the connection cable into the corresponding receptor at the
bottom of your navigation system .
2. Insert the power adapter (2) now into the cigarette lighter socket and ensure, that
it will not lose contact while driving. This could cause a malfunction.
3. Hint: Remove the power adapter from the cigarette lighter socket when ending a
trip or when parking the car for a extended period of time. Otherwise the car
3. Fix the complete holding device with the supplied screw and tighten it slightly by
hand.
4. Now insert the navigation system into the holder. You must pay attention to a firm
seating of the clip holder.
5. Set the inclination angle by screwing the bicycle holder in according to your
requirements. Now turn the screws finger-tight.
Note: After assembly, protect your navigation system from dust and dirt using the
storage pocket. The storage pocket does not protect against rain or moisture. Take
care that the navigation system does not exposed to moisture. This may damage the
electronic parts.
When you use the navigation system, make the navigation system upright with the
GPS antenna (13) will get a strong signal. If the signal is not good, please adjust the
direction of the GPS antenna to receive the signal.
NAV-600 Operation manual
INSTALLATION
9