GPS is a satellite-backed system for determining your position. With the help of 24
satellites revolving around the earth, it is possible to determine your position on earth
with the accuracy of a few meters. The satellite signals are received by the antenna
of the built-in GPS receiver, which must have a “line of sight” to at least 4 of these.
•
Note:
By limited line of sight (e.g. in tunnels, between houses, in woods or also in
vehicles with metal-coated windows) it is not possible to determine the position. The
satellite reception however automatically picks up again as soon as the obstacle
has been passed and there line of sight is reestablished again.
The GPS receiver consumes additional power. This is especially of concern, when
running on batteries. To conserve power do not turn on the GPS receiver unnecessarily.
However, you can also switch the device off by means of the
ON/OFF
switch in the
case of a shorter interruption to your journey. Pressing the same switch again will
activate a restart. The GPS receiver will also be reactivated at the same time, if
navigation software is still active. Here, it can take a short time for the position to
be updated again, according to the reception situation.
•
Note:
Please note that your appliance is preset to not shut down automatically after
a few minutes without activity. You can Change this preset in the Settings mode.
• If the GPS receiver has not been active for some hours, it must orientate itself again.
This process may take a while.
Memory Card Quick Installation
This option is only available to you if your navigation system is equipped with a prepared
memory card. In this case, you will ready be able to use the Navigation function of
your device after a short time, without carrying out the pre-installation on a PC.
• The following installation limits the Navigation to the area which is pre-installed on
your memory card.
You must carry out these steps to put the navigation into operation in your car:
1.Read and adhere to the safety instructions on p.2.
2.Install the remaining components of the navigation system.
3.Press the
BATTERY ON/OFF
button to start your navigation system. If the instructions
of
Step1
have not yet been executed, then do it now. The battery should be charged.
The accumulator will be charged by means of the car power supply if necessary.
• Insert the pre-installed memory card in the navigation system software will start
automatically. Follow the instructions on the screen.
NOTES:
• The memory card must always be inserted into the device during the use of the
navigation system. A Soft Reset will have to be carried out to restart the navigation
system, if the memory card is removed during its use, even for a short time.
• The software installation will have to be carried out again following a Hard Reset.
• Carry out a Hard Reset initially, if you want to reinstall the navigation software.
Set the date and time by means of the Settings button and the date/time control button,
if this has not yet taken place. Set the applicable time zone, if available.
Starting Navigation
1.Switch on your navigation system.
2.The navigation software will start automatically or after clicking on the navigation
control button, according to the version.
3.Press on the button for entering the destination. Then start the navigation by clicking
on Navigate. YOU will receive the route information on the screen, augmented by
language statements, after a short time, if the satellite reception is adequate. Please
take information about the further operation of the Navigation software from the
comprehensive User Handbook on the Navigation CD.
NAV-600 Operation manual
GPS (Global Positioning System)
13
Содержание NAV-600
Страница 1: ...NAV 600 OPERATION MANUAL ...