7.1 Selecting stations
To find a station, press Select. The frequency display starts to run up as MSY5 scans
the FM band. Alternatively, you can scan up or down by pressing and holding the >> or
<<buttons or tune manually with quick presses, or by turning the Select control.
Presets to store an FM preset, press and hold button Pres s
et until the display
shows the Save preset screen. Select one of the 20 presets to save the currently
playing station.
To select a preset, press Pres s
et briefly, then select one of the listed Preset stations.
When a preset station is playing, it shows
1,2,3 etc in the bottom middle of the
screen.
7.2 Now playing information
While an FM station is playing, the screen shows one of the two following sets data:
If RDS information is available, by default the service name (i.e. station name) is
displayed.
You can cycle through further RDS information by pressing Info .Each time you press
Info, another set of information is displayed, cycling through RDS radio text, RDS
programme type, frequency and today’s date.
If no RDS information is available, the currently tuned frequency is shown.
7.3 Settings
Scan settings
By default, FM scans stop at any available station. This may result in a poor
signal-to-noise ratio (hiss) from weak stations. To change the scan settings to stop only
at stations with good signal strength, select Menu > Scan setting > Strong stations only?
> Yes.
Audio settings
24
