4
Installation of front lights on front fork
Install front lights on top part of front fork as shown in picture. If
you are installing the front mudguard, also insert front mudguard
at the back of the fork before nut (4). Refer to images below.
1) Front light arm
2) Bolt
3) Washer
4) Nut
5) ON button
6) To replace the 4x AAA batteries of the light when empty remove
screw (6)
and twist off
lid (7).
To re-install lid look for small metal
nut inside the light casing, place it into cradle on inside of light
casing at position (8), turn screw (6) into nut just enough so that it
is flush with the nut, then twist lid (7) back onto light and fully
tighten screw (6).
WARNING!
Make sure the light is installed firmly and safely before
riding. Tighten all nuts and bolts
1
2
3
6
5
7
6
8
WARNING!
The
minimum
insertion mark (Figure FS1) on
the upper handle-stem must
NOT be visible when inserted.
Failure to do so may result in
the stem malfunctioning and
can cause you to fall.
CAUTION!
Pinching hazard.
Keep clear of moving parts.
Figure FS2
Figure FS1
Installation of the handle-stem and handle-bar (continued)
WARNING!
The handle-bar must be
installed securely. Test before riding.
Refer to section of quick-release
levers in this manual for correct
operation.
CAUTION!
The folding stem
should fold to the right side of
the
bike.
The
handle-bar
should
be
approximately
parallel to the bike frame
when fully folded.
Fold
carefully. Take care not to
damage the bike during the
folding procedure. Make sure
to leave enough slack for all
wires to avoid damaging wires
while folding.
WARNING!
Test the installation of the
handle-stem before riding as shown in Figure
FS2. The stem should not move easily left and
right and it should not come loose during
riding.
Reflectors
Reflectors need to be installed at front
handle-bar (facing forward, color-less).
There are reflectors at rear light of the
bike (facing backwards, red) on pedals
and on spokes on front and rear
wheel. Every 3 months check that all
reflectors are clean, installed securely
and not covered up by any accessories.
Figure BE1: Bell.
Attach the bell firmly to the
handle bar, close to the handle-
grip with the supplied bolt.
Tighten with a screw driver. The
trigger faces the rider. Push the
trigger down by tapping it with
your
finger
briefly
in
the
direction of the arrow and
release it to ring the bell.
Bell
Trigger
Use the bell to make other people aware of you in traffic, e.g.
before passing a pedestrian. Make sure the bell is functional and
securely installed.
Installation of the bell
Handle-Bar
© Leitner Pty Ltd 2020
9