LEISUREWIZE emove EM303, Руководство пользователя

Страница: 4 / 20

INTRODUCTION
Congratulations on choosing the emove EM303 caravan manoeuvring system. This has been produced
according to very high standards and has undergone careful quality control procedures.
Simply by using the remote control handset you can move your caravan effortlessly into any position required
within operating guidelines. Soft start and soft stop technology allows you to manoeuvre your caravan even
more accurately without any shocks.
The caravan manoeuvring system consists of two 12V motor-power rollers, a 12V electronic control unit and a
remote control handset. To function, the motor-powered rollers must be engaged against the tyres of your
caravan. The supplied cross actuation device enables you to engage both rollers at the same time from one side
of your caravan. Once this is done the manoeuvring system is ready for operation. The remote control will allow
you to move your caravan in any direction. You can even rotate the caravan on its own axis, without moving
forwards or backwards ( this functionjust can workunderthe “single-axle function”).
Before proceeding with installation and starting to use the manoeuvring system, please read
this manual very carefully and be aware of all the safety instructions! The owner of the
caravan will always be responsible for correct use. Keep this manual inside your caravan for
future reference.
INTENDED USE
The emove EM303 caravan manoeuvring system is suitable for single axle and double axle caravans.
Suitable only for L-profiled and U-profiled chassis with a chassis thickness between min. 2.8mm and max.
3.5mm.
Depending on the weight of the caravan, the manoeuvring system cannot overcome obstructions that are more
than about 2cm in height without assistance (please use wedges as a ramp).
The standard installation kit only provides parts for installing the caravan manoeuvring system within the
measurements given in Fig. 14.
SPECIFICATIONS
Designation emove EM303
Operational voltage 12 Volt DC
Average current consumption 20 Ampere
Maximum current consumption 100 Ampere
Transmitting frequency remote control 868MHz
Speed approx. 9cm per sec.
Weight (2 motor set) approx. 37kg (exclusive battery)
Minimum width (caravan/trailer) 1800mm
Maximum width (caravan/trailer) 2500mm
Maximum tyre width 205mm
Power source (battery) LiFePO
4
: 12V, 20Ah
Lead acid: 12V, 80Ah (min.)
INSTALLATION - SAFETY GUIDELINES
Read this user manual carefully before installation and use. Failure to comply with
these rules could result in serious injury or damage to property.
These symbols identify important safety precautions. They mean CAUTION! WARNING!
SAFETY FIRST! IMPORTANT INFORMATION!
Before starting installation under the caravan :
Check the towing load of your vehicle and the gross weight of your caravan in order to establish whether they
are designed for the additional weight. The manoeuvring system itself has a weight of about 37kg and a
traditional lead acid battery has a weight of about 20-25kg .
Check the minimal installation dimensions of the manoeuvring system based on figure 14.
Permissible overall Weight single axle (2 motors) 2250kg hard flat surfaces, 1800kg other surfaces,
1500kg on 18% gradient.
Permissible overall Weight double axle (2 motors) 2250kg hard flat surfaces, 1800kg other surfaces,
1500kg on 18% gradient.
Permissible overall Weight double axle (4 motors) 3500kg hard flat surfaces, 2500kg other surfaces,
1800kg on 18% gradient.
EM303 Manual AW 2018.qxp_Layout 1 09/11/2018 15:13 Page 5