22
Remove test piece
•
Relieve
clamping jaws (11)
with
locking lever (9)
and remove welding sample.
• The tool is ready for further testing.
Ready to transport
• Push
locking lever (9)
down until to the limit.
• Unplug tool from the line/mains.
• Unplug cable from
socket (1)
und put it into the storage case.
• Close the storage case.
Change of clamping jaws
• Flexible jaws
– Fasten adjustment
screw (10)
against the
clamping jaw (11).
– Unscrew the
cocking-lever shaft (22)
from
clamping jaw (11)
with a 8 mm spanner.
– Remove
clamping jaw (11).
• Fixed clamping jaws
– Unscrew
set screw (16)
with 4 mm hexagonal box spanner.
– Pull off
clamping jaw (11).
• Assemble clamping jaws in reverse order.
– Watch the alignment of
clamping jaws (11).
• Read the test values on the
display (4)
• By pressing the key
–
‹‹
, the
sliding carriage (12)
will return to its programmed starting position.
The position display reverts back to the absolute jaw spacing.
• By pressing the key
›
again, the test data are cancelled and a new tensile test can be started.
Reading test data
Содержание EXAMO 300F USB
Страница 55: ......
