32
Instruction manual V 2.3 – 02/2009
Adjusting the front pressure plate
•
Position the pressure plate (
86
)
correctly, insert clamping lever
(
89
) and fasten the pressure
plate slightly (tightening the
clamping lever just a bit).
•
Height-adjust the pressure plate
via screws (
87
).
The upper edges of the two
pressure plates (86) and (80)
must be at the same height and
parallel to each other.
The clearance angle of the front
pressure plate (
86
) is adjusted with
a setscrew (
88
), which is accessi-
ble through an opening on the un-
derside of the knife holder (see
drawing).
•
Insert a blade (
77
) and tighten
the clamping mechanism (
89
)
lightly.
The setscrews (
87
) on the underside of the knife holder (accessible
through openings in the underside of the knife holder) enable you to
height-adjust the front pressure plate. A size- 2 Allen key is needed to do
the adjustment.
•
With screw (
88
) adjust pressure plate (
86
) so that only the upper edge
of the pressure plate actually exerts pressure on the blade. A gap must
remain visible (
Fig. 31/
). A small screwdriver (ca. 3.0 x 70) is neces-
sary for adjustment.
•
When adjusting, ensure that a gap of approx. 0.4-0.8 mm remains be-
tween the two pressure plates with the clamping mechanism not yet
tightened (
Fig. 31/
).
Fig. 31
87
88
86
ca. 0,05 mm
0,4 - 0,8 mm
89
5.
Operation
77
Содержание RM2125
Страница 2: ......
