Leica mojo 3D, Руководство пользователя

Страница: 349 / 378

Leica mojo3D, mojo3D Enhancements 349

When all sections widths are correctly set, the Implement Width shown
should match the total width of the physical implement.
55. If automatic section control is being used, then additional information will have
to be entered.
•
Overlap limit : the percentage amount of overlap that is to be allowed before
the section is turned off.
• Low Speed Shutoff : the minimum travel speed for a section before it is
turned off.
• Off latency : the number of seconds it takes from the section being turned off
until the actual application stops.
• On latency : the number of seconds it takes from the section being turned on
until the actual application starts.

Refer to "7 Automatic Section Control" for more detail on the individual
settings.
56. When you have entered all required data tap to continue.
The Correction Source screen appears.
57. On the Correction Source screen, select the correction source to use for your
system.
58. Tap to continue.