iCON robot 60/iCON builder 60, Operation
33
4.3
Remote Control Setup
Setup step-by-step
Available for iCON robot 60.
4.4
Power Functions
Turning the instru-
ment on
Press and hold power key (
) for 2 s.
The Instrument must have a power supply.
Turning the instru-
ment off
Press and hold power key (
) for 5 s.
The instrument must be on.
Power Options
menu
Press and hold power key (
) for 2 s to open
Power Options
menu.
Instrument must be on.
Step
Description
Refer to "4.1 Instrument Setup" for the initial instrument setup onto a
tripod. To remove the instrument carry handle: Press and hold the four
unlock push buttons and lift off the handle.
1.
To install the CommunicationHandle, first make sure that the interface
connection on the underside of the handle is on the same side as the
Communication side cover. Then press and hold the four unlock push
buttons and attach the handle.
Ensure that there is a tight fit with the instrument after releasing the push
buttons. If no connection can be found, re-check that handle is seated
firmly.
2.
Swing the CommunicationHandle antenna into an upright position.
Refer to field software manual for additional information.
006314_001
1a
1b
1c
1c
1b
1b
1b
1b
2
Option
Description
Turn off
Turn iCON robot 60/iCON builder 60 instrument off.
Stand-by
Put iCON robot 60/iCON builder 60 instrument into
stand-by mode.
In stand-by mode, the iCON robot 60/iCON
builder 60 instrument shuts down and
reduces power consumption. Rebooting from
stand-by mode is quicker than a cold start
after turning off.
Lock keyboard
Locks the keyboard. Option turns to
Unlock
keyboard
.
Turn off touch screen
Disables touch screen. Option turns to
Turn on
touch screen
.
