GMX902 GG/GMX902 GNSS, Safety Directions
19
4.7
FCC Statement, Applicable in U.S.
The greyed paragraph below is only applicable for products without radio.
Warning
Warning
Changes or modifications not expressly approved by Leica Geosystems for
compliance could void the user's authority to operate the equipment.
Labelling
GMX902 GG/
GMX902 GNSS
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television recep-
tion, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and the receiver.
•
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference
received, including interference that may cause
undesired operation.
Advisory notice: this receiver uses the P-Code signal,
which by U.S. policy, may be switched off without notice.
Type:
GMX...
Art.No.
XXXXXX
. . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . .
. . . . . . . . . . . .
Manufactured: XX.2005
S.No.
Made in Switzerland
XXXXX
GMX902_07
All manuals and user guides at all-guides.com
