10
GMX902 GG/GMX902 GNSS, Operation
Setup with
LAN/WAN
The following diagram shows the basic equipment setup for an instrument
connected locally to GNSS Spider via LAN/WAN.
Connecting
instrument to
GNSS Spider
Any further description of the configuration of the instrument is not part of the
User Manual.
Refer to the "GMX900 Series Getting Started Guide with Leica GNSS Spider"
which is included on the GMX900 CD.
2.3
Operating Principles
GMX902
GG/GMX902 GNSS
operation
Recommended operation of the GMX902 GG/GMX902 GNSS is with the GMX902
GG/GMX902 GNSS Web interface or Leica GNSS Spider software or with the
Leica Binary 2 (LB2) interface. Contact your Leica Geosystems representative
for information on LB2 documentation.
The GMX902 GG/GMX902 GNSS instrument is delivered with default settings
which cover the needs of the typical user. Use the Web interface or Leica GNSS
Spider to adjust the GMX902 GG/GMX902 GNSS settings.
Sleep mode
The instrument reverts to sleep mode when
•
the power falls below 10.5 V.
•
there is no traffic on the ports P1/P2 for more than 10 minutes after the
initial instrument start up, or for more than the configured sleep mode
time.
The sleep mode is switched off per default.
Use the tool "GMX902ConfigTool" on the GMX900 CD to change the sleep
mode.
When in sleep mode, the PWR LED is off. Any traffic on the serial port will wake
up the instrument again.
a) Computer
b) Power supply
c)
Serial-IP convertor
d) GMX902 GG/GMX902 GNSS
e) Surge arrestor
f)
GNSS antenna
g) Connection via LAN/WAN
GMX902_05
a
b
d
e
f
c
g
LAN/
WAN
All manuals and user guides at all-guides.com
