Leica DM E, Инструкция по эксплуатации

Страница: 4 / 8

3
2.0 Installation
1 Unplug the microscope and remove the eyepieces.
2 Raise the stage to the highest position using the microscope coarse focus control knob.
3 Lower the condenser to the lowest position using the condenser focus control knob.
4 Using the Allen wrench which came with the microscope, remove the two alignment set
screws which are holding the condenser in place. Save these alignment set screws for
possible later use.
5 Remove the condenser from the condenser bracket.
6 Raise the condenser bracket to the highest position using the condenser focus.
7 Remove the blue daylight filter from the underside of the condenser. Save this filter for
possible later use.
8 Insert the lens holder from the Koehler kit into the underside of the condenser.
9 Using the 2.5mm wrench provided with the Koehler kit, remove the mounting bolts holding
down the light port window to the microscope stand.
10 Remove the light port window. Save this for possible later use.
11 Remove the power cord from the back of the instrument.
12 Carefully tip the microscope on its back and remove the 4 screws holding the rubber feet.
13 While holding the base in place with one hand, tip the microscope back onto its base to its
normal operating position.
14 Carefully lift the microscope off of its base.
15 Looking into the light port, you will see a lens held into a circular fixture with a mounting
ring. At the six o’clock position of the circular fixture (closest to you) there is a notch.
16 Insert the ball of the 2.5mm wrench into the notch and pull up on the mounting ring.
The mounting ring should pop out of the light port.
17 Hold a tissue over the light port and turn the base upside down. The lens will fall into the
tissue. Save this for possible later use.
18 While the base is upside down, open the lamp door.
19 Take the aspherical lens which is provided with the Koehler kit and insert it into the light
port so that the diffused, spherical side is flush with the bottom of the light port. You will be
able to see this through the opened lamp door.