42
Remove and fit the spreading disk drive motor
1. Disconnect the power supply.
2. Disconnect the electrical cable at the terminal box and make a note of
the cable route for later installation.
3. Undo the pin screws
(2)
on the spreading disk
3
and pull the
spreading disk
(3)
downwards.
4. Undo the cheesehead screws
(4)
from below and remove them and
then remove the drive motor
(1)
.
5. Take the spacer ring off the motor shaft.
6. Clean the support surface of the spacer ring and motor shaft.
7. Apply a thin coating of conventional copper paste to the motor shaft.
8. Install the parts in reverse order.
Note for installation:
Apply medium-strength liquid thread locker (Loctite) to the cheesehead
screws
(4)
on the spreader disk
(3)
and insert them.
5 Maintenance and cleaning
