OMEGA
Installation Manual
Edition Dec. 2004
Omega
platform lift
page 23 of 24
Adjustment of the loading ramps
•
Be sure the control ramps on the railway and all limit switches are adjusted before
looking for the ramps.
•
Adjust the ramps to achieve a 45 °
angle between the platform and ramp
when the barrier is in horizontal
position. When the barrier is open, the
ramp has to fit to the bottom of the
landing area.
•
During closed and drive position of the
platform, the ramps are used as safety
pads also. To get a secure switch
function it is necessary to move the
fixing of the ramps as far outside as
possible.
Note:
Look for a safety switch function, but do not adjust too “secure”!
This would require some service after a few weeks.
•
Check the loading ramps for proper operation.
Note:
Remember to check the travel clearances of the carriage.
Do not let the unit run past the upper limit position.
•
Before you close the carriage, ensure that all screws fixing the limit switches are
secured.
bearing for
the bord
Move the joint for the ramp as far as
possible into direction of the arrow.
Check if there is enough space to open
and to close the ramp.
