BD
A CAP
TOS MIF
ARE / CAP
TOS iChar
ge MIF
ARE 22-09-22 (GB)
22
RESETTING TO FACTORY SETTINGS (RESET)
If a reset to factory settings is required, all master and user cards are deleted. With an installation card the basic
functions (close and open) can be carried out. The bolt is retracted, and the lock must be reprogrammed with a
master card. The reset function can be used with the help of the master card and programming card No. 3 (P3:
Reset). For this, the lock must be open. The programming card set must be bought separately from LEHMANN
Vertriebsgesellschaft mbH & Co. KG. The cards are for universal use.
ACTIVATION AND DEACTIVATION OF AUTO LOCKING
With the programming card “P4: Auto Locking”, the function „Automatic locking“ can be activated and deactivated in
the operating mode „assigned use“. Once the function is activated, the lock closes automatically after 5 seconds after
opening the lock with an authorized transponder.
The function can be carried out by using the master card and the programming card “P4: Auto Locking”. To do this,
the lock must be in the mode „assigned use“ and in an open position. If the operating mode changes, this function
is automatically deactivated. The programming card must be purchased separately from LEHMANN Vertriebsgesell-
schaft mbH & Co. KG. The card can be used universally.
Resetting to factory settings
Hold the master card
in front of the lock.
Hold the programming card
“P3: Reset” in front of the
lock.
Hold the programming card
“P3: Reset” in front of the
lock again.
Hold the master card in
front of the lock. During
the initialisation, no
transponders may be within
reading range of the lock.
after about 10 seconds
NOTE:
If the „automatic locking“ function is activated, hold the master card in front of the lock immediately after
opening the lock in order to start programming. Otherwise the lock will lock automatically after 5 seconds.
Configuring the lock including programming transponders is only possible when the lock is open.
