4
TROUBLESHOOTING
Status LED is enabled but not blinking and the load will not turn ON:
Check the circuit breaker to be sure it is functioning.
Load will not turn ON:
• Press ON/OFF button. The load should turn ON. If not:
• Check the light bulb and/or motor switch on the fan mechanism.
• Turn off power to the circuit then check wire connections.
Load will not turn OFF:
Make sure there is a solid ground ground connection.
NOTE:
The time delay can be set from 30 seconds to 30 minutes. Ensure that the time delay is set to the desired delay and that there is
no movement within the sensor’s view for that time period.
• To quickly test the unit for proper operation, turn the time delay to minimum and move out of the sensor’s view. Lights should turn
off after 30 seconds.
• Press the ON/OFF button. If load does not turn off, turn off power to the circuit then check wire connections.
• If load still does not turn off call 800-879-8585 for technical support.
CHANGING THE COLOR OF THE UNIT
1. Remove the wallplate
2. Firmly grasp the edges of the front cover directly below the lens where it says “open.” Push in one side first until it pops out, then
the other side. Remove front cover from the unit (see Fig. 5).
3. Take the new color front cover, place the top peg in first then snap in each side one at a time (see Fig. 7).
Time
Delay
30sec.
30mi
n.
5min.
10mi
n.
20m
in.
11543r
1
Fig 7: Replace Front Cover
