I N S T A L L A T I O N
©Vantage, 12/1/2016 / IS-0471-B
RadioLink EasyTouch II ScenePoint Relay, MODEL: RR1XXX-XXXX
page 3 of 3
FCC ID: PII-RDS2000
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
-
-
Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications to this product not expressly approved by Vantage Controls could
void the user’s authority to operate this product.
Decorah
Ring
Foam
Sealer
Matrix
Base
Diffusers
Buttons
1 to 5
DIFFUSERS
BUTTONS
ONE BUTTON
DIFFUSERS 1 & 5
TWO & THREE BUTTON
DIFFUSERS 1, 3, 4 & 5
FOUR & EIVE BUTTON
ALL DIFFUSERS 1 – 5
Light sensor
and IR
Sensor bar
is, recessed
between
buttons.
The sensors
are
not
supported
with 1 (one)
button
stations
Break Off
TABS
for Ganging
(FRONT)
(SIDE) (BACK)
Cleaning Buttons and Faceplates
Turn the breaker to the station OFF
Dampen a soft cloth in water and wring-out to
barely damp – almost dry
Use a light buffing motion to wipe clean
Do not take the station apart
Never spray station with any cleaners
Line Drawing:
Changing the Number of Buttons
EasyTouch II keypads will support 1 to 5 buttons. The number of buttons may be changed on a keypad after it has been installed by following
these instructions.
Turn the circuit breaker off and make sure no voltage is present at the ScenePoint station being modifying
.
1.
Change the software file to the new number of buttons with proper engraving.
2.
Order the new buttons for proper engraving.
3.
Disconnect power from the station
4.
Replace the old button configuration with the new button configuration using the chart example below.
5.
When finished replacing the buttons and the station is fully assembled, test the
new buttons operation.
Proper Button Assembly of EasyTouch II Stations
Disassemble:
1.
Faceplate: Remove faceplate.
2.
Decorah Ring: Remove Decorah button ring.
3.
EasyTouch II Buttons: Remove buttons that need replaced.
4.
LED Button Diffuser:
Remove
or
add
diffusers for new button
configuration, using the examples below.
Assemble:
1.
LED Diffusers: Double check diffusers are in the correct position.
2.
Buttons: Place buttons in proper positions for new configuration. Buttons
Must be in the correct position following tapered design from top to
bottom. Buttons have a small number on the back border, 1 is top and 5
is bottom.
3.
Decorah Button Ring: Replace, securely snaps in place.
4.
Faceplate: Replace.
