Doc No. FM0862 issue 3 Page 7
ZXT494
Ser No:
10154095
Iss-1
ID 33040508
20W12
Registering a PIR Detector onto a
Touchsafe Pro
Nursecall system
1. Put the Touchsafe Pro Master Panel into Telecare registration mode; touch the screen and Logon as an Engineer or a Manager
(password required),
then from the main menu page touch the
Telecare
button to open the screen shown b
elow…
2. Enter the PIR Detector ID
3. Press the
Close
button to exit Telecare mode and the Nursecall panel is now back in normal operating mode.
4. Activate the PIR and check the call is displayed on the Nursecall pa
nel like this…
The screen banner is
yellow
for a bed occupancy call (
Touch the banner to display notes
).
Press the
Accept
button on the banner to silence the alarm - this will also
notify all other panels the call is being dealt with.
The screen banner changes to
purple
when a call is accepted.
You must visit the appropriate Nursecall Call Point to cancel the call.
Deleting a PIR Detector from a
Touchsafe Pro
Nursecall system
Select the PIR ID to be deleted from the
Delete Telecare Device
pull-d
own list box (prefixed with a “T33”).
Details of the PIR selected will be displayed in the
Room
,
House Code
and
ID
boxes below.
If the details shown are correct press the
Delete
button.
Press the
Close
button to exit.
Refer to the Touchsafe Pro Display Panel user guide (Doc No. FM5505) provided with the Nursecall system
for more information.
Tynetec and Aidcall operate a policy of continuous improvement and reserve the right to change product specifications without notice.
If any variation to the details contained in this document are suspected pleas
e contact Tynetec’s custome
r support dept on 01670 352371.
The 8 digit ID is printed on a label on the rear of the PIR detector.
Note: this ID will always start with
33
xxxxxx.
Touch the
Add Telecare Device
box then use the on-screen keypad to enter the ID.
Hint: enter a zone in the
Filter
box to narrow the search for the room (see below).
Select the users Call Point ID from the
Room
pull-down list box then press
Save
.
Note: this is the room unit that will be used to cancel the call.
Use keypad to enter
8 digit ID here
Select the relevant
Call Point ID here
Save when done
Close to exit mode
On-screen keypad
CALLING
CANCEL
HC 345 ID 001
Press the
LIGHT GREY
button to cancel the call
