Doc No. FM0862 issue 3 Page 5
Registering a PIR Detector onto an
Advent XT
warden call system
1. Put the Advent XT system into radio device lear
n mode…
2. Switch the PIR ON and wait 15 seconds for the exit time to expire, then move in front of the PIR
…
3. Exit the Advent XT system radio device learn m
ode…
4. Switch the PIR ON and allow 15 seconds for the exit time to expire, activate the PIR, allow the 15 second entry time to expire
and check a
“
Bed Occupancy
”
alarm is reported on the warden call system.
Deleting a PIR Detector from an
Advent XT
warden call system
Press the
LINE
key and wait for the “
Ready
” prompt.
Enter
5 0 0 1
followed by the
key.
Enter the flat number the PIR is being deleted from followed by the
key.
Activate the PIR to be deleted.
Wait for the
“
Pendant Disabled
–
Enter Flat
” pr
ompt.
Press the
#
key and wait for the “
Ready
” prompt
, then press the
LINE
key to clear the connection.
Refer to the Advent XT
operator’s
manual (Doc No. FM0420) provided with the warden call system for more
information on programming/testing radio devices and operation of the intruder mode.
Usi
ng the Manager’s DECT telepho
ne;
Press the
LINE
key and wait for the “
Ready
” prom
pt.
Enter
5 0 0 0
followed by the
key.
Enter the flat number the PIR is being installed in followed by the
key.
You now have 1 minute to activate the PIR detector.
“
Re
ady”
Using the Manager’s DECT telephone;
Press the
#
key and wait for the
“
Ready
” p
rompt.
Press the
LINE
key to clear the connection and the warden call system is
now back in normal operating mode.
Note: it is assumed the PIR detection and operation
LED
’
s are both enabled
…
The PIR detection LED will
FLASH RED
then after the 15
second entry delay the operation LED will
FLASH RED
.
W
ait for the “
Enter Location Code
” prompt
then press
0
(no location) followed by the
key.
Wait for the
“
Pendant Enabled
–
Enter Flat
” prompt.
“
Ready”
