9
1
2
3
4
1
1. Remove the cable covers
C
.
IMPORTANT
: Fully extend
arm assembly
10
to ensure
enough slack in cables.
2. Route your cables through the
arm assembly
10
shown
—
to avoid pinching.
3. Reattach the cable
covers
C
over the cables.
3
2
C
C
C
C
10
Manage Cables
Your TV should adjust easily when moved, then stay in place. If your TV is too loose or too tight, adjust
the side tension knob
T
by hand or use hex key
14
for additional tightening.
NOTE:
Once your TV is in place, tighten the tension knob
T
to prevent unwanted movement.
NOTE:
Additional tension can be applied using hex key
14
.
T
1. Loosen
screw
13
.
3. Retighten
screw
13
.
2. Adjust the leveling
of your TV by turning
the level screw
L
.
13
13
TILT ADJUSTMENT
LEVEL ADJUSTMENT
TV Adjustments
1. Remove your TV (PAGE 9).
2. Open the cover plates and remove two screws
11
and two
screws
12
to release arm assembly
10
.
3. Reposition the arm assembly
10
on the wall plate (STEP 3.1).
4. Reattach the two screws
11
and two screws
12
(STEP 3.1)
and close the cover plates.
5. Hang your TV onto the arm assembly
10
following STEP 3.2.
3
2
a
1
a
2
b
2
c
1
b
5
b
5
a
4
b
4
a
12
12
11
14
11
08
10
08
10
LATERAL SHIFT
Your TV should adjust easily when moved, then stay in place. ONLY if needed, adjust the
extension/retraction arm tension with screw
R
using a 1/8 inch hex key (not supplied).
CAUTION:
Avoid potential personal injury or property damage!
DO NOT remove bolts
R
, only turn enough for slight adjustment.
REMOVING THE TV
EXTEND / RETRACT -- ONLY IF NECESSARY
CAUTION:
Screw
13
MUST
be loosened before
turning screw
L
.
L
14
HEAVY! You may need assistance with this step.
HEAVY! You may need assistance with this step.
13
14
05
14
CAUTION:
Avoid potential injuries or property damage!
Do NOT adjust the arm position from center for concrete
applications. Arm
10
MUST remain centered in wall plate
08
for all concrete applications!
R
