TROUBLESHOOTING
During house ID binding, the LED is not fl ashing on some devices.
• If LED is solid green before initiating house ID binding:
The device already has another house ID. Reset it to the factory default so
that it can be bound to the desired house ID. Resetting to factory defaults is
described in “I made a confi guration mistake. I need to start over.”
• If LED is solid yellow after initiating house ID binding:
The device may be out of range of the initiating device. Add a MRR2
Wireless Repeater to boost signal range.
During binding or customizing, all LEDs stop fl ashing before I press .
The 5 minute binding process timer may have expired. Restart the timer by
repeating steps 1 and 2 of the procedure you were using. Notice that the devices
you previously excluded are fl ashing green; those included are fl ashing yellow;
simply fi nish the process from where you left off.
The device LED fl ashes red when I press .
The house or room confi guration may be locked.
Go to any house level scene controller and simultaneously press and buttons
B and E until the scene controller LED fl ashes GREEN.
Go back to the previously locked device and press .
• If it fl ashes green or yellow, you have unlocked the house confi guration.
• If the device still fl ashes red, the confi guration may be locked
by a room level scene controller such as the MRD6 or MRH6.
Go to the room scene controller and simultaneously press and buttons
B and E until the scene controller LED fl ashes GREEN. (See LOCK ROOM
CONFIGURATION.)
Go back to the previously locked device and press .
• If it fl ashes green or yellow, you have unlocked the room confi guration.
• If the device still fl ashes red, the confi guration may be locked
by another room level scene controller in the house. Repeat the procedure
from different controllers until the device is no longer fl ashing red.
I made a configuration mistake. I need to start over.
To reset any Miro wireless device to factory default settings, press and hold
- - until the LED changes to solid yellow (approximately 10 seconds).
During the process, the LED fl ashes yellow. When complete, it becomes solid
yellow. The device can then be reconfi gured, exactly like any new device.
CLEANING
Clean only using a cloth dampened with water and a little mild detergent. Use of
solvents or hydrocarbon-based cleaners may cause permanent damage.
