SET HOUSE ID
All Miro wireless devices installed in the same home must acquire the same
unique House ID before use. This process is known as house binding. Each Miro
wireless device is bound to all other Miro wireless devices in the house.
New Installation
1. With all devices installed and energized, make sure that every Miro wireless
device LED is yellow. If any LED is off, be sure the circuit breaker is on and the
device is correctly installed.
2. Press on any device paddle until
the LED fl ashes yellow (about 2
seconds). This indicates that it has
acquired a unique House ID.
3. Make sure that all other Miro
wireless device LEDs are fl ashing
green, indicating that they have
acquired the same House ID.
4. Return to the device used in step 2, which is still fl ashing yellow. Press
until the LED changes to solid green (about 2 seconds). All device LEDs in the
House change to solid green, indicating house binding is complete.
Adding an MRD6 to an Existing Installation
If you’re adding or replacing a MRD6 in a Miro wireless installation that is
already operating, the new MRD6 must acquire the same House ID as the other
Miro wireless devices in the house. After the new MRD6 is powered up, the LED
should be solid yellow. This indicates that it has not yet acquired a House ID. To
acquire the House ID for the existing system:
1. Press on any
previously bound
device until the LED fl ashes yellow (about 2
seconds).
2. Verify that the newly added MRD6 LED is fl ashing green, indicating that it has
acquired the House ID.
3. Return to the same
previously bound
device used in step 1 and press until
the LED changes to solid green (about 2 seconds). All device LEDs should now
be solid green.
When you see
in the instructions,
firmly press and
hold both the top
and bottom of
the paddle until
the LED changes
(about 2 seconds).
A
B
C
D
E
A
B
C
D
E
When you see in the
instructions, touch
the top of the paddle
as directed.
When you see in the
instructions, touch the
bottom of the paddle
as directed.
