LEGRAND Middle Atlantic Forum, Инструкция

Страница: 21 / 22

Page 21
INSTALLING WIREMOLD MODPOWER OPTIONS TO TABLE (IF PURCHASED)
1. Refer to corresponding On Surface
ModPower installation instructions for
Primary (MDSA10-WH),
Middle (MDCA3-WH), and End (MDEA3-WH)
units at www.legrandav.com.
They provide installation details for
under-table screw-in mounting and how to
wire the units correctly.
NOTE : Adjust torque on power driver to lightest
setting and only increase as necessary.
2. While referencing the On Surface ModPower
installation instructions, use power driver,
Phillips bit, and the wood screws provided
with the unit(s) to attach to the desired
pre-drilled hole locations on the bottom of
your corresponding table top (V).
( FIGURE AF , FIGURE AG , and FIGURE AH )
NOTE :
• Panels removed for clarity.
• Adjacent ModPower units must be mounted
less than or equal to 6’ (305mm) apart to
accommodate the cable length provided.
• The image shown is provided as an example.
Your specific installation may differ.
You may have purchased any number of optional Wiremold On Surface ModPower System Primary,
Middle, or End units to provide power to your optional table(s).
NOTE :
• If purchased, a primary ModPower unit is required to run any additional middle and end units.
• A single primary unit may run power to an additional 7 units (for a maximum of 8 total).
3. Connect your unit(s)
as specified in the
On Surface ModPower
installation instructions
and run the power
cable(s) through your
table as desired using
“Understanding Cable
Management” on page
20.
Example ModPower Unit Mounting Locations
(and Additional Pre-Drilled Screw Locations)
on the Underside of the 3 Person Arc Table Top
Additional Pre-Drilled
Screw Locations
ModPower Units
FIGURE AF
Additional
Pre-Drilled Screw
Locations
ModPower
Units
Example Mounting Locations
(and Additional Pre-Drilled Screw Locations)
on the Underside of the 3 Person Angle Table
FIGURE AG
FIGURE AH
Additional
Pre-Drilled
Screw
Locations
ModPower
Units
Example Mounting Locations
(and Additional Pre-Drilled Screw Locations) on the Underside of
the 5 Person Angle Table
V
V
V