www.kenall.com | P: 800-4-Kenall | F: 262-891-9701 | 10200 55th Street Kenosha, Wisconsin 53144, USA
This product complies with the Buy American Act: manufactured in the United State swith more than 50% of the component cost of US origin It may be covered by patents
found at www.kenall.com/patents. Content of specification sheets is subject to change; please consult www.kenall.com for current product details. ©2019 Kenall Mfg.Co.
2
INSTALLATION INSTRUCTIONS
LTSIU_F-5828_091118
SERVICE INSTRUCTIONS
2. Rotate latches and open door, which is retained by stainless steel cables.
3. Loosen wing nuts and remove Wiring Cover. See figure 2.
4. Connect weather tight electrical service to installed lt connector and feed wire leads into user supplied
junction box.
5. Connect electrical service:
Black- input line, 277-480VAC
White- neutral
Copper or green- ground
6. Replace Wiring Cover and secure with wing nuts.
7. Close door and secure rotating latches.
LTSIU series LED modules are not field replacable.
It is recommended that all service function be done after the fixture is removed from service.
Before beginning any service operation, be sure the power to the fixture is off.
To replace an LED driver or surge protector-
1. Open door, which is retained by stainless steel cables.
2. Loosen wing nuts and remove Wiring Cover.
See Figure 3.
3. Fuses can now be checked and replaced
if necessary.
4. Loosen wing nut securing the driver bracket
and slid to liftout and expose the driver and
surge protector.
5. Test and replace the necessary components
6. Secure bracket, wiring cover and door.
Figure 2
Figure 3
