IG Series
LED Parking Luminaire
Junction Box and Pendant Mount
INSTALLATION INSTRUCTIONS
1 of 2
LPN00305X0001A0_A
TO INSTALL:
1
4
2
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precautions should always be followed
including the following:
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
1. DANGER
- Risk of shock- Disconnect power before installation.
DANGER
– Risque de choc – Couper l’alimentation avant l’installation.
2. This luminaire must be installed in accordance with the NEC or your local
electrical code. If you are not familiar with these codes and requirements, consult
a qualified electrician.
Ce produit doit être installé conformément à NEC ou votre code électrique local.
Si vous n’êtes pas familier avec ces codes et ces exigences, veuillez contacter un
électricien qualifié.
3. DO NOT lift luminaire by the power leads.
4. DO NOT carry or lift luminaire by wireform. Wireform is only for supporting luminaire while
making wiring connections.
SAVE THESE INSTRUCTIONS FOR FUTURE
REFERENCE
JUNCTION BOX MOUNTING
STEP 1:
Attach mounting plate to customer
supplied junction box with the clips on the
Mounting Plate directed parallel to vehicle
traffic as shown in Figure 2. Torque to
20 in-lbs. See
Figure 1 and 2.
STEP 2:
For hands-free wiring locate the wireform
on luminaire and attach it to the clip on
the Mounting Plate. See
Figure 3.
STEP 3:
Make wiring connections per
“Electrical
Connections”
section.
STEP 4:
After wiring connections have been made,
tuck all wires into junction box ensuring
that no wires are pinched. Remove
wireform on luminaire from the clip on the
mounting plate. Fold the wireform back
down onto the luminaire.
STEP 5:
Attach luminaire to the Mounting Plate
by pressing up on the luminaire until the
slots on the luminaire engage with the
clips on the Mounting Plate and rotate
until clips lock securely. To secure install
a minimum of (2) supplied screws across
from each other into the mounting plate
clips on the underside of the luminaire.
See
Figure 4.
NOTE:
May require extra pressure on
luminaire to engage clips into slots. Only
apply pressure on housing body NOT on
the luminaire lens.
NOTE:
If the mounting plate clips
become deformed during installation,
slightly reopen the clips back up using a
screwdriver to ensure proper install of
luminaire.
(4) Luminaire Slots
(4) Clips
Mounting
Plate
Mounting Plate
Wireform
Mounting
Plate Clip
View of Underneath
Luminaire
(4) Mounting
Plate Clips
Luminaire
Slots
(2) Screws
Mounting Plate
3
Wireform
Clips
Mounting Plate
NOTE:
• During installation and maintenance handle
the luminaire only by the housing NOT by the
lens.
