HP-4 Wet Location Surface Mount Installation Instructions
6 of 9
© 2019 FINELITE, INC. ALL RIGHTS RESERVED. Form - 98439. V2 EFFECTIVE DA
TE: 09/09/19
tooltip
B. Mount Starter to Structure
Ceiling
Starter
1/4"-20 Threaded Rod (by others)
1/4"-20 Sealing Washer (provided)
1/4"-20 Sealing Washer (provided)
1/4"-20 Sealing Washer (provided)
1/4"-20 Nut (by others)
1/4"-20 Nut (by others)
1/4"-20 Lag Bolt (by others)
Option 1 (Shown) - Mount to Threaded Rod
Option 2 - Mount to Structure
Option 1 (Shown) - Mount to Threaded Rod
•
Align mounting holes with hanging hardware.
•
Install 1/4"-20 nut and 1/4"-20 sealing washer onto 1/4"-20 threaded rod.
•
CRITICAL: If installing a joiner luminaire in the next step, leave nut loose,
allowing luminaire to hang at an angle.
•
If there is no joiner/ender, then tighten nuts fully.
PROCEED TO STEP 7.
Option 2 - Mount to Structure
•
Place luminaire onto wall/ceiling and mount to structure support with
hardware appropriate for the structure type.
•
CRITICAL: If installing a joiner luminaire in the next step, leave loose,
allowing luminaire to hang at an angle.
•
If there is no joiner/ender, then tighten nuts fully.
PROCEED TO STEP 7.
1-1/2"
Step 4 - Mounting Starter to Structure
1/4"-20 Nut
(by others)
1/4"-20 Sealing Washer
(provided)
1/4"-20 Lag Bolt
(by others)
1/4"-20 Sealing Washer
(provided)
1/4"-20 Nut
(by others)
Mounting Option 1
Mounting Option 2
Threaded Rod
(by others)
1/4"-20 Sealing Washer
(provided)
