Installation Instructions
ODA330
7
11. Mark and drill four 5/16" or 8mm holes with a depth of 2
7/8" in four of eight inside holes where remaining anchors
will be installed making sure the following rules are
followed. (See Figure 2) and (See Figure 5)
•
ONE hole must be used adjacent to each of the
FOUR gussets.
•
A total of TWO holes must be used for each HALF
of the plate.
Figure 5
12. Install four M8 x 75mm concrete anchors through four inside
holes drilled in Step 11. (See Figure 6)
Figure 6
13. Insert pipe (not included) in to attach assembly (A) until
holes align for installation. (See Figure 7)
Figure 7
14. Use two 3/8-16 x 4 1/4" hex head bolts (D), four washers
(C), four spacers (F) and two 3/8-16 hex nuts (B). (See
Figure 8)
IMPORTANT ! :
Make sure spacers (F) are properly
oriented to fit around pipe with the lines vertical.
Figure 8
x
x
x
x
x
x
x
x
Acceptable hole configuration
Unacceptable hole configuration
(G) x 4
12
13
(A)
ODAC pipe (not included)
14
(D) x 2
(B) x 2
(F) x 4
(C) x 4
spacers (F) positioned to
fit around pipe
lines vertical
