Installation Instructions
LF49/50/55UxP, LF49/50/55UxP-B2B
15
Cabling
1.
Cables may be placed through the corners of the display
frame. (See Figure 10)
2.
Attach cable tie mounts (G) as necessary to keep cables
from being damaged in pinch points of the kiosk. (See
Figure 10)
IMPORTANT ! :
Avoid pinching the cables inside the
kiosk. Damage to cables may occur.
Figure 10
Storage Panel
WARNING:
Exceeding the weight capacity can result in
serious personal injury or damage to equipment! It is the
installer’s responsibility to make sure the weight of
components attached to the storage panel does not exceed
25 lbs (11.3 kg).
1.
Install AV component(s) to the storage panel (C) using the
hardware and instructions included with the component(s).
Either screws or cable ties may be used to fasten
component(s) to the panel.
2.
Place storage panel (C) inside the kiosk, lining up the holes
in the storage panel with the holes in the lower part of the
kiosk. (See Figure 11)
3.
Hold storage panel (C) directly behind screw holes and
fasten using two 10-24 x 3/16" Phillips screws (F). (See
Figure 11)
Figure 11
Possible locations
for cable tie mounts.
This area may also
be used to place
cables, but may be
too tight for certain
cables
1
2
(F) x 2
3
