LF49/50/55UxP, LF49/50/55UxP-B2B
Installation Instructions
12
WARNING:
TIPPING HAZARD!
Close and lock door(s)
before removing the hex head bolts from the pallet. (See
Figure 3)
Keep door(s) closed and locked
until the kiosk is
fully secured to the floor. Kiosk may tip if door(s) are open
when kiosk is not securely fastened to pallet or to floor.
9.
Remove and discard the four hex head bolts and washers
connecting the kiosk to the pallet, and lift kiosk off wood
pallet. (See Figure 3)
Figure 3
Bolt Kiosk to Floor
WARNING:
Do NOT install floor kiosks and back-to-back
floor kiosks to any surface other than concrete! Concrete
flooring must be at least 4" in thickness and NOT be covered
with any other type of flooring material. Concrete anchors
must be installed directly into concrete surface.
1.
Using kiosk (A) as a template, mark center of four mounting
holes (the holes where kiosk was attached to pallet) and
move kiosk to allow access to drill holes. (See Figure 4)
2.
Using a 3/8” drill bit, drill a hole 3-1/2” in depth at each
marked location. (See Figure 4) and (See Figure 5)
3.
Blow each hole clean of any concrete debris with an air
hose or compressed air in a can. (See Figure 5)
IMPORTANT ! :
Do NOT modify the anchors or advance
the bolt in the anchors prior to installation!
4.
Place kiosk (A) on top of drilled holes making sure that
drilled holes are centered within the mounting holes in
kiosk.
Figure 4
5.
Use a hammer to drive anchors (E) through kiosk mounting
holes into the drilled holes until the bolt head is firmly seated
against the kiosk. (See Figure 4) and (See Figure 5)
6.
Tighten each anchor by turning the head three to four turns
past finger tight. (See Figure 5)
Figure 5
7.
Repeat Steps 5 and 6 for each mounting hole.
9
x 4
[LF49/50/55UxP shown as example]
1
2
E x 4
5
6
(E x 4)
2
3/8”
3-1/2” deep
3
air
(E) x 4
5
(A)
(E) x 4
6
(A)
hose
