Installation Instructions
LF49/50/55UxP, LF49/50/55UxP-B2B
11
ASSEMBLY AND INSTALLATION
Remove Kiosk from Packaging
NOTE:
These instructions apply to both the LF49/50/55UxP
(one-sided display) and LF49/50/55UxP-B2B models
(two-sided display), unless otherwise noted. If installing
a -B2B, simply repeat the installation steps on both
sides of the kiosk, unless otherwise noted.
NOTE:
The packaging film on the kiosk should remain in place
as long as possible during the kiosk installation to avoid
scratching the kiosk. Remove packaging film after
installation is complete.
1.
Remove key from display frame. (See Figure 1)
2.
Use the key to unlock and open the swing door. (See Figure 1)
3.
Lift up the lower panel latch to release lower panel. Lift up
opposite lower panel latch to release the opposite lower
panel. (See Figure 2)
4.
Remove both lower panels by pulling out 1" - 2" on the
latch
side
of each lower panel. (See Figure 2)
5.
Slide each panel to the non-latch side to remove lower
panels. (See Figure 2)
6.
(One-sided display only)
Raise the flag lock on the inside
of each side of the rear panel. (See Figure 2)
7.
(One-sided display only)
Grasp and "squeeze" the sides
of the rear panel from behind the kiosk.
8.
(One-sided display only)
Lift to remove the rear panel from
the kiosk. (See Figure 2)
Figure 1
1
Key ships
taped in
this area
2
Swing door
lock
Swing
door
[LF49/50/55UxP shown as example]
Figure 2
3
3
4
4
5
5
6
Rear panel
Lower panels
Lower panel
latch
Flag locks
[LF49/50/55UxP shown as example]
7
7
8
