65a
STOP&GO automatic resetting for DX
3
Manual changeover switches for DX
3
DX
3
6000
C63
DX
3
6000
C63
G
MSI
OFF
ON
OFF
OFF
G
DX
3
6000
C63
DX
3
6000
C63
MSI
OFF
OFF
G
DX
3
6000
C63
DX
3
6000
C63
MSI
ON
OFF
G
DX
3
6000
C63
DX
3
6000
C63
MSI
Temporarily electrical disturbances and other external events can cause
unwanted tripping of different devices protecting electrical installation
STOP&GO verifies automatically the state of the installation, before
resetting and launches a visual and audible alarm signal in case of
permanent fault detection (short-circuit or residual current)
After verifying the state of the installation, STOP&GO automatic resets the
associated protection device in order to immediatly re-establish power
supply and avoid unwanted consequences
STOP&GO does not protect the installation against lightning strikes
For an efficient protection against lightning, use voltage surge
protectors
The Autotest version is specially suitable for installations equipped with
residual current protection devices (RCD's and RCBOs)
STOP&GO periodically does an automatic test of the functionning
of residual current protection devices. The manual test is no longer
needed
Alarm
Heating
Swimming pool Refrigerator
Access control
Freezer
Aquarium
Watering
Mains fault due to temporarily
electrical disturbances
Electrical devices are not powered
anymore
STOP&GO automatic resets the
associated protection device in
order to immediatly re-establish
power supply
Installation without STOP&GO
Installation with STOP&GO
1- The power is on the general network
The MCB behind the window, connected to the
generator is on the OFF position
2- Switch OFF the main MCB
3- Slide the window in order to change the power supply
4- Switch ON the MCB connected to the generator
