Leggett & Platt Sleep Comfort, Руководство пользователя

Страница: 17 / 24

Sleep Comfort™ Adjustable Base Owners Manual 99301076-b
17
sc-mr2 remote controL Programming
(2 remote controls - 2 bases)
The six step procedure below is required to program 2 remote controls to operate 2 bases.
Before beginning, make certain the base is plugged into a working grounded electrical outlet.
If
programming fails, initiate the programming procedure a second time.
NOTE: OPERATE ONLY ONE
(1) REMOTE CONTROL AT A TIME. OPERATING TWO (2) REMOTE CONTROLS AT THE SAME TIME WILL
MOMENTARILY BLOCk BOTH RF SIGNALS AND PREvENT BOTH CONTROLS FROM FUNCTIONING.
REMOTE
CONTROL 1
REMOTE
CONTROL 2
BED 1
BED 2
steP 2
On remote control 1, simultaneously press and
hold the
PoS 1 and head massage on/off buttons .
The transmission indicator light will flash slowly
and then flash rapidly to indicate programming
mode. Continue to hold for 5 seconds and then
release the buttons ( FIGURE 8 ).
steP 3
Repeat Step 1 and Step 2 with remote control 2.
steP 4
Locate the power down box for base 2 and
press the
learn button for 1 second and
release. (
FIGURE 7
).
steP 5
On remote control 1, simultaneously press and
hold the
PoS 1 and head massage on/off buttons .
The transmission indicator light will flash slowly
and then flash rapidly to indicate programming
mode.
Continue to hold for 5 seconds and then
release the buttons ( FIGURE 8 ).
steP 6
Repeat Step 4 and Step 5 with remote control 2.
Two remote controls are now programmed to
operate two bases. steP 1
Locate the power down box for base 1 and
press the learn button for 1 second and release
(
FIGURE 7 ) .
POWER
DOWN BOx
LEARN
BUTTON
FIGURE 7: Power down box learn button.
POS 1
BUTTON
HEAD
MASSAGE
ON/OFF
BUTTON
TRANSMISSION
INDICATOR LIGHT
FIGURE 8