Leetro MPC6575, Руководство производителя

Страница: 26 / 53

MPC6575-Close-loop Laser Engraving &Cutting Controller (Rev. 1.0)
14
version are mismatched, contact your supplier for correct one.
2. Run laserCut program, and re-download the configuration file.
5.8.6 Mismatched DLL and Firmware
Causes:
The DLL with which the processing file was created is unmatched with the firmware version.
Solution :
1. Open the destination directory of LASERCUT program and run the VerCheckTool.exe to
check if the DLL version matches with the firmware version. If the DLL version and firmware
version are mismatched, contact your supplier for correct one.
2. Delete the processing file in MPC6515 and re-download the processing file matching with
the firmware.
5.8.7 Mismatched *.HRD and *.FMW
Causes:
The upgraded firmware is not supported by the current hardware.
Solution :
Re-upgrade the firmware as instructed in the manual. If the problem can’t be solved yet,
contact your supplier for support.
5.8.8 Servo Out-of-Step Alarm
Causes:
1. Feedback communication error on servo encoder
2.
Settings of feedback pulse logic and voltage command logic are opposite.
3. Wrong wiring between the servo controller and the servo motor.
4. Servo motor is power-off.
5. Conflicting settings of servo motor drive parameters and controller parameters.
MiSMATCHED DLL AND
FMW
MISMATCHED HRD AND
FMW
REDOWNLOAD FMW
Servo Out of Step