Jan 2012
T190 Iss.2
Page 13 of 38
4.5.
Electrical connection
Risk of injury
.
Risk of damage to unit. Observe correct mains supply voltage.
Risk of electrical shock. Do not connect with wet hands.
No user serviceable parts. Do not remove service panels.
Disconnect unit in an emergency.
Before connecting the incubator, check that the electrical supply corresponds with the values on the
incubator data plate. If in doubt consult a qualified electrician.
The incubator is designed to operate from a single phase electrical supply of: 230V AC ±10% 50/60Hz.
This incubator MUST be connected to a protective earthed supply.
Further details can be found in the technical data.
Section 15.1
Plug the supplied power lead into the IEC connector on the rear of the incubator.
Plug the other end of the IEC lead into the electrical supply.
In an emergency you may need to isolate the incubator from the electrical supply by disconnecting the
mains supply plug. Make sure that the mains supply plug is easily accessible.
5. Getting started
5.1.
Start up
Insert the pre-formatted SD card (supplied) into the slot to the right of the controller.
Turn on the unit using the power switch on the rear panel.
The controller will boot up and perform a self-check.