v.12.10.19
Ledra Brands Inc.
www.LedraBrands.com
In a continuing effort to offer the best product possible we reserve the right to change, without notice, specifications or materials that in our opinion will not alter the function of the product.
15774 Gateway Circle Tustin, CA 92780
P 714.259.9959 F 714.259.9969
HAND TIGHTEN
HAND TIGHTEN
De-energize circuit before installation.
Ensure placement of fixture will accommodate New Construction Mounting Plate and
LED Module Assembly. Refer to product cut sheet and cut hole into ceiling. Adjust
bar hangers to size and secure New Construction Mounting Plate as required using
integral nails and screws or suspend in T- Bar grid ceiling. Ensure the fixture is properly
supported and attached to building. Feed building flexible electrical conduit through
ceiling cutout and ensure enough conduit length for future serviceability. Open wiring
compartment and use knockouts to connect electrical conduit to wiring compartment
using appropriate hardware (not provided). Connect line, neutral, and ground wires
to building electrical supply. Close driver compartment lid. For future servicing, do not
fasten driver compartment to any structure.
Secure New Construction Mounting Plate by adjusting bar hangers to size and
secure New Construction Mounting Plate as required using integral nails and
screws or suspend in T-Bar grid ceiling. Ensure the fixture is properly supported
and attached to building. Refer to product cut sheet and cut hole into ceiling as
required. Feed building flexible electrical conduit through ceiling cutout and ensure
enough conduit length for future serviceability. Open wiring compartment and use
knockouts to connect electrical conduit to wiring compartment using appropriate
hardware (not provided). Connect line, neutral, and ground wires to building
electrical supply. Close driver compartment lid. For future servicing, do not fasten
driver compartment to any structure.
New Construction Mounting Plate not used. Ensure area above finished ceiling
will accommodate placement of fixture and driver compartment. Refer to product
cut sheet and cut hole into ceiling as required. Feed building electrical conduit
through ceiling cutout and ensure enough conduit length for future serviceability.
Feed building flexible electrical conduit through ceiling cutout and ensure enough
conduit length for future serviceability. Open wiring compartment and use knockouts
to connect electrical conduit to wiring compartment using appropriate hardware
(not provided). Connect line, neutral, and ground wires to building electrical supply
Close driver compartment lid. For future servicing, do not fasten driver compartment
to any structure
INSTRUCTIONS FOR USE
STEP 1A - EXISTING CEILING:
STEP 1B - NEW CONSTRUCTION:
STEP 1C - RETROFIT:
HOLE CUTOUT 3-3/8” DIAMETER
*NOT FOR USE WITH RETROFIT
Carefully remove bezel from LED Module Assembly. Sharp or flat objects not
recommended as they can damage the bezel or snap locks.
Connect the quick disconnect from driver compartment to LED Module Assembly.
Insert the LED Module Assembly through the ceiling cutout.
Hand tighten the Phillips head fastening screws to secure the LED Module
Assembly. Ensure the LED Module Assembly is securely fastened against the
ceiling, but has not recessed into soft ceiling tiles due to over tightening.
Carefully insert pinhole bezel into LED Module Assembly. Press firmly until bezel
snaps into place. If necessary, use suction cup (provided) to remove bezel.
Sharp or flat objects not recommended as they can damage the bezel or snap locks.
Energize circuit and test for proper operation.
STEP 2
STEP 3
STEP 4
STEP 5
STEP 6
STEP 6
