LEDJ SPECTRA BANK 4, 6, 8
OPERATION
Operation
After you have connected the Spectra Banks to the mains, the 10mm LED bar/s
start chasing.
The LCD display lights up and you can then choose the desired mode via the
MODE
button:
• Stand alone mode
• Auto mode
• DMX mode
• Master/slave mode
• Sound activation mode
Stand-alone mode
Chaser:
A chase is a sequence of different steps that will be called up one after another in a
continuous loop. You can select up to 14 different pre-programmed chases.
Selecting a chase:
Press the SET UP button. Select the desired chase (00-14) via the
UP
or
DOWN
buttons.
Select the desired chase sequence via the UP and DOWN buttons. (Step time/
SP
or strobe speed/
FS
).
FS
= Flash speed from 00 – 100%
SP
= Step time from 00 – 100% time/minute.
Auto mode
- In auto mode the chases are called up automatically in a continuous loop.
-The desired speed of the loops can be selected via the
UP
and
DOWN
buttons.
Master/Slave Mode:
- The master/slave operation enables several units to be synchronized to one
master unit.
- On the rear panel of the Spectra Bank you will find an XLR plug and an XLR socket
which can be used for connecting several units.
Daisy Chain Connection
1) Connect the (male) 3 pin connector side of the DMX cable to the output (female) 3 pin
connector of the first fixture
2) Connect the end of the cable coming from the first fixture which will have a (female) 3 pin
connector to the input connector of the next fixture consisting of a (male) 3 pin connector.
Proceed to connect from the output as stated above to the input of the following fixture
and so on.
