Ledj Rubix RGB 3D Panel, Руководство пользователя

Страница: 12 / 16

www.prolight.co.uk Rubix RGB 3D Panel User Manual
12
Operating instructions
Auto mode:
To access the auto mode, press the “MENU” button and use the “UP” and “DOWN” buttons on the rear
of the unit to show
AUTO
on the LED display. Press the “ENTER” button to confirm the setting. The
unit will now run through all the built-in programs.
To exit out of any of the above options, press the
“MENU” button.
Built-in program mode:
To access the built-in program mode press “MENU” until the display shows
Pro
on the LED display.
Press the “ENTER” button and use the “UP” and “DOWN” buttons to select a program from
Pr.01
~
Pr.28
. To change the speed of programs
Pr.02
~
Pr.28
press the “ENTER” button and
then use the “UP” and “DOWN” buttons to select any value from
SP.01
~
SP.FL
. Press the “ENTER”
button to confirm the setting, then use the “UP” and “DOWN” buttons to select the flash speed value
from
FL.00
~
FL.99
. Press the “ENTER” button to confirm the setting. In
Pr.01
you are able to
set a specific static pattern. When in
Pr.01
press the “ENTER” button and then use the “UP” and
“DOWN” buttons to go through the static patterns. Press the “ENTER” button to confirm the setting, then
use the “UP” and “DOWN” buttons to select the flash speed value from
FL.00
~
FL.99
. Press the
“ENTER” button to confirm the setting. To exit out of any of the above options, press the “MENU” button.
Master/slave mode:
To set the master unit, press the “MENU” button on the rear of the master unit then select your desired
program (sound active, auto, static pattern or one of the built-in programs). To set the other units in
slave mode, press the
“MENU” button on the rear of the unit to show
SLAu
on the LED display and
press the “ENTER” button to confirm the setting. The units will now run in sequence with the master
unit. If you would require fully synchronised patterns/colours please ensure the ‘DMX sync setting’
(page 13) is set to
--On
. To exit out of any of the above options, press the “MENU” button.
Please ensure that all slave units are set to the same DMX channel mode as the master unit.
Colour mix mode:
To access the colour mix mode press “MENU” button until
CoLr
shows on the LED display.
Now press the “ENTER” button and use the “UP” and “DOWN” buttons to select the brightness of
segment one red between
r1.00
~
r1.FL
. Press the “ENTER” button and repeat for segment one
green (
g1
), segment one blue (
b1
), segment two red (
r2
), segment two green (
g2
), segment two
blue (
b2
), segment three red (
r3
), segment three green (
g3
) and segment three blue (
b3
).
Value: 00 - FL (00 = low brightness, FL = high brightness)
To exit out of any of the above options, press the “MENU” button.
Sound sensitivity:
To access the sound sensitivity setting, press the “MENU” button and use the “UP” and “DOWN”
buttons on the rear of the unit to show
Soud
on the LED display. Press the “ENTER” button and
then use the “UP” and “DOWN” buttons to select any value from
SU.00
~
SU.31
. Press the
“ENTER” button to confirm the setting. To exit out of any of the above options, press the “MENU” button.