Ledco Premier 4, Руководство по эксплуатации

Страница: 20 / 43

20
5-1 UNPACKING AND INVENTORY
With the laminator on an unobstructed, level surface, perform the following checkout
before threading the machine with film.
WARNING: Make sure the power cord is clear of the underside of the machine
prior to operation to avoid overheating the cord.
MISE EN GARDE : S'assurer que le cordon d'alimentation ne passe pas sous la
machine, ce qui l'exposerait à la chaleur élevée produite par le sabot infèrieur.
ADVERTENCIA : Antes de operar la máquina, asegúrese que el cordón electrico
no está debajo de la misma, para evitar el recalentamiento del cordón.
1. Remove all packing straps, rubber bands, tape, and plastic ties from the machine.
Remove the protective paper from the safety shield.
2. Make sure the heat, fan, and drive switches are off before you plug in the machine.
The fan and heat switches are labeled accordingly. "0" indicates the off position.
The drive switch positions for forward and reverse are labeled. The reverse position
is momentary and will turn off when released. The speed control is directly above
the temperature indicator and is labeled with a hare and a tortoise.
3. Plug the machine into a working outlet of at least 15 amps. Plugging in the machine
does not power on any control unless a switch has been left on. Plug in the machine
and turn on the heat. The heat indicator lamp in the heat switch will come on. It will
stay on until the machine has reached set temperature.
Adjust the heat controls.
To raise temperature:
•
Press red button once to display set point value screen
•
Press red button again to raise set point value
•
Hold red button to raise set point value rapidly
•
Wait five seconds for actual temperature to display
To lower temperature:
•
Press red button once to access set point value screen
•
Press blue button to lower set point value
•
Hold blue button to decrease set point rapidly
•
Wait five seconds for actual temperature to display
To switch from Fahrenheit to Celsius:
•
Hold blue button for five seconds
•
Use red button to change from degrees F to degrees C
•
Wait five seconds for actual temperature to display
4. Always leave the rollers open when you turn off the machine. Close the rollers when
you are going to thread the machine.