Lectronics Long Ranger LRIII-MB, Сервисный бюллетень

Страница: 2 / 4

Strip the insulation back approximately 1/8 inch
and twist the bare strands for easier insertion into
terminals as shown in step 4.
3.
The connectors should look like this after crimp-
ing. The red wire must have the larger terminal
attached.
Small terminal
5.
Remove the terminal cover and the retaining
bracket from the new battery assembly.
6.
Push the battery out of the mounting assembly
from the side opposite the retaining bracket.
7.
Insert wires into the terminals and crimp them
firmly with a crimping tool.
NOTE: To ensure proper polarity for the new battery
pack, the Red wire (+) must be attached to the large
terminal and the Green or Black wire (-) must be
attached to the small terminal.
4.
Install the new mounting bracket assembly to
the Long Ranger and tighten the screws.
8.