Page 12
STARTING THE UNIT
BEFORE YOU START SOFTWARE AND AFTER ALL CABLE ARE CONNECTED, PUT THE
SWITCH OF THE BLACK BOX ON. LEAVE IT OPEN UNTILL YOU CLOSE SOFTWARE. MAKE
SURE THE KNIFE IS IN DOWN POSITION. (HANDLE IN TOP POSITION) TO CHANGE ANY
CONNECTION, PUT THE SWITCH OFF.
The solenoid unit is adjusted and tested before
shipping.
When the solenoids are in push position (on) they
must be at their maximum extension (or very
close to it). If they are not at there full extension for
some reason, they will overheat quickly.
It is important to check the action of each solenoid
before you start, to determine that they are all
functioning correctly. The easiest way to do this is
with the self-test that is usually available with your
design software.
Each plunger should move freely when not in
action. If they are sticking, try to determine the
cause or call for technical assistance.
