Leadtek Amor C101, Руководство пользователя

Страница: 44 / 53

More Security, More Convenience
44
Figure 8.8
There are two options for Output Level . (Figure 8.9)
High : Choose it, the IO Pins work as a switch which is closed.
Low : Choose it, the IO Pins work as a switch which is switching off
.
Figure 8.9
3.18.4 IO Pins for IO Alarm Linkage
Figure 9.0
I/O PINS: 1 Output 2 Output 3 Alarm input 4 Input (GND)
Input pins: The input pins can be used for 1-way external sensor input. For example, you may connect a
Person Infrared Sensor (PIP) to it for motion detection. When external sensor triggered, IP CAMERA can be
programmed to send an email with picture or control the internal relay output.
If you link an external alarm device with Pin3 and Pin4, when select
Alarm Input Armed (Figure 8.7), external
alarm is enabled.
Output pins : The output pins can be enable IO linkage on alarm.
You can also use & to control IO output Switch ON/OFF (See Figure 4.1).
NOTE : All the pins work as switch only.
3.19 Send Mail on Alarm
Choose it, it will send
picture and mail inform to customer’s e-mail once alarmed. (Firstly you should finish the
Mail Service Settings. Figure 8.0)
NOTE : It usually will send 6 snapshots by one email to your mailbox for each alarm triggered. Each alarm will
last for 60 seconds.
Upload Image on Alarm
Enable Upload Image on Alarm to set upload images to FTP once alarmed.
Upload Interval : Set the upload interval (Seconds).