Leader LV 5480, Функциональное меню пояснения

Страница: 210 / 246

9. EYE PATTERN DISPLAY (SER02/SER09)
202
9.8.3 Selecting the Filter
To select the filter that is used during jitter measurement, follow the procedure below. The
selected filter is indicated in the lower right of the display.
If you change this setting, the filter that you selected for the eye pattern display also
changes.
Reference Section 9.7.3, “Selecting the Filter”
Procedure
EYE → F•3 JITTER SETUP → F•3 FILTER: 100kHz / 1kHz / 100Hz / 10Hz / TIMING /
ALIGNMENT
9.8.4 Turning Cursors On and Off
To configure cursor settings, press F•3 CURSOR/TRIGGER on the JITTER SETUP menu.
EYE → F•3 JITTER SETUP → F•3 CURSOR/TRIGGER →
Figure 9-18 CURSOR/TRIGGER menu
To turn cursors on and off, follow the procedure shown below.
When the cursors are turned on, the REF cursors are displayed in yellow (X) and light blue
(Y), and the DELTA cursors are displayed in purple (X) and green (Y). The values of
DELTA-REF appear as measured values in the upper part of the screen.
Procedure
EYE → F•3 JITTER SETUP → F•3 CURSOR/TRIGGER → F•1 ON/OFF R ESET → F•1
CURSOR: ON / OFF