Leader LT 4600A, Инструкция по эксплуатации

Страница: 51 / 114

9. ANALOG BLACK OUTPUT (BLACK SETTING)
41
9. ANALOG BLACK OUTPUT (BLACK SETTING)
Three analog black signals are output from the BLACK OUT connectors on the rear panel.
You can set the output signals using BLACK SETTING. Specify the settings under BLACK
SETTING after you have finished configuring the system settings. Note that if you change the
system settings, the settings specified using BLACK SETTING are reset to their factory
defaults.
Reference Chapter 8, “CONFIGURING THE SYSTEM (SYSTEM SETTING)”
In BLACK SETTING, you can set the three signals separately. The procedure below is for black
1 (1A, 1B), but the same procedure can be applied to black 2 and 3.
9.1 Selecting the Black Format
To select the black signal format, follow the procedure below.
To use a normal composite black signal, select NTSC BB or PAL BB.
２．ＢＬＫ１ ＦＯＲＭＡＴ

＊１０８０ｉ／５９．９４
ＣＨＡＮＧＥ ＢＬＫ１ ＦＯＲＭＡＴ ？
■ＯＫ □ＣＡＮＣＥＬ

Procedure
BLACK SETTING
→ BLACK1 SIGNAL → BLK1 FORMAT
The formats that you can select vary depending on the frequency group that you selected in
section 8.1 “Selecting the Frequency Group,” as follows.
BLK* FORMAT
SYSTEM SELECT
60.00Hz GROUP 59.94Hz GROUP 50.00Hz GROUP
1080i/60 Yes No No
1080i/59.94 No Yes No
1080i/50 No No Yes
1080p/30 Yes No No
1080p/29.97 No Yes No
1080p/25 No No Yes
1080p/24 Yes No No
1080p/23.98 No Yes No
1080psF/24 Yes No No
1080psF/23.98 No Yes No
720p/60 Yes No No
720p/59.94 No Yes No
720p/50 No No Yes