Leader Maple Cream Machine
Year: 2014
Page: 7
6.
Install the inner paddle. The inner paddle holder slot (in the paddle bar) is the one not open to the edge of
the pan.
Completed Paddle Alignment
7.
When all three positioning adjustments (side-to-side, height, angle) for each paddle have been made,
tighten the thumbscrew and wing nuts on each paddle holder. Rotate the pan and motor manually to
check for clearance of height and on the edge.
8.
When you start the cream machine ensure the paddles are not scraping the actual surface or side of the
pan. Adjust paddles as necessary.
b.
Loosen the wing nuts on the paddle holder and slide
the paddle assembly so the projection on the bottom
of the paddle will be approximately 1/16” from the
edge of the pan. Tighten the wing nuts.
c.
The height of the paddle should be adjusted so that the
bottom of the paddle is approximately 1/16” above
the highest point of the bottom of the pan.
a.
The alignment marks for the paddle are used the same
as for the outer paddle.
b.
Loosen the wing nuts on the paddle holder and slide it
until the paddle projects beyond the center of the pan
by approximately 1/8”.
c.
The height of the paddle should be adjusted so that the
bottom of the paddle is approximately 1/16” above the
highest point of the bottom of the pan.
