LEAB CHAMP 12 V, Руководство пользователя

Страница: 23 / 28

13.2 MagCodePowerPort installation instructions
Fig. 3: MagCode
PowerSystems clip
and port
NOTE!
An existing car socket can easily be replaced by a
MagCode PowerPort, as both have the same diameter. If
installing elsewhere, we recommend visiting a specialist
workshop.
To install the MagCode
PowerPort in place of an existing
car socket, proceed as follows:
DANGER!
Short circuit hazard - Remove the fuse be-
fore starting work.
1. Pull out the existing car socket.
NOTE!
Note the polarity of the wires.
2. Cut the cable.
OR…
3. Drill a new installation opening (Ø 28 mm).
ð
The installation opening is prepared.
4. Slide the MagCode PowerPort , with or without spacer
ring, into the installation opening.
5. Screw the MagCode
PowerPort
on the back with a nut
(M28).
6. Connect the cables with each other by soldering,
crimping or with connection terminals.
7. Put the fuse back in place.
ð
The MagCode
PowerPort
is installed.
13.3 MagCodePowerClip assembly instructions
To install the device, proceed as follows:
1. Cut off the old connector.
NOTE!
Note the polarity of the wires.
2. Screw on the MagCode PowerClip .
3. Select the appropriate strain relief for the cable thickness.
4. If necessary, shorten the cable grommet by passing the cables through the
grommet and the strain relief and attaching the wire end ferrules.
23 LEAB Automotive GmbH Thorshammer 6 24866 Busdorf
LEAB Automotive GmbH 13 Appendix