lemaitrefx.com
6
1.
The fog output time is set using the ‘Duration’ control. 0 to Max, and the time between
successive fog outputs is set using the ‘Interval’ control. 0 to Max. Continual flow can be
achieved if ‘Interval’ setting is 0
(Figure 1, Page 7).
The standard Remote Handset cable may be extended from the machine, and
operated effectively away from the Stage Fogger DMX. The maximum recommended
cable length is 500 Feet.
The Stage Fogger DMX
Remote Handset was designed to indicate operation modes . These
are as follows:
Slow flashing output:
Indicates unit is not ready to operate but still in heating mode, fog
is not available at this point.
Quick flashing output:
Indicates unit is ready to operate but still in heating mode, some
fog is available at this point.
Solid Led:
Indicates that the unit is ready to fog at full output.
No Illumination:
Problem. Check Remote Handset connection on the rear panel of Stage
Fogger DMX. If this fails to correct the problem, contact your local Le Maitre dealer.
The Stage Fogger DMX comes equipped with onboard DMX Control as a standard feature
(Figure 2, Page 7.)
1) Plug in the 5 pin DMX cable into the DMX IN connector located on the rear of the Stage
Fogger DMX. A terminator may be required if the DMX OUT is not used.
2) Select the DMX address assigned to the Stage Fogger DMX by using the DMX ADDRESS
thumbwheel selector loacated on the rear of the Stage Fogger DMX. If a valid DMX signal
is availble then the Stage Fogger DMX ignores the settings on the standard remote.
3) Fog output is varied by the DMX signal. 0% is off and 1% - 100% is fog intensity.
4) 15 Amp chassis fuse on the back of the machine.
Remote Handset Operations
Remote Handset LED Indicator
External Remote Connector
Remote and External Control Features
DMX Operation
