DigitalBooster DB-4 – Manual
-
14
-
At the
following sample
the
On-/Off switch function
assign the
four-fold address
block 1 to 4
and the
WatchDog-Function
the
addresses 5 to 8
.
The
On-/Off switch function
will be controlled by the
address 3
and the
WatchDog-
Function
with the
address 5
.
On-/Off sw. Function
not used
not used
Stop
not used
round / red / -
round / red / -
round / red / -
round / red / -
1
2
3
4
straight / green / +
straight / green / +
straight / green / +
straight / green / +
not used
not used
Go
not used
On-/ Off sw. Function
WatchDog
inactive
not used
not used
not used
round / red / -
round / red / -
round / red / -
round / red / -
5
6
7
8
straight / green / +
straight / green / +
straight / green / +
straight / green / +
active
not used
not used
not used
WatchDog
7.3. Address Section Programming:
1.
Switch-on
your
digital layout incl. DigitalBooster DB-4
(the
green LED
of the
DB-4 will glow
).
Depress
1x short
the
key S1
next to the jumpers
of the
DB-4
. Now the
green
LED flashes
.
This indicates
that the
DB-4
is in the
programming mode
for the
address-section
of the
On-/Off switch-function
.
During the programming
process
is the track section which is
connected
to the
DB-4
switched
voltage
free
.
2.
Switch
now
one turnout
from the
group of four
which has been selected for the
address section
of the
On-/Off switch function
via the
keyboard
of the
digital
command station
or the
remote control
. For
programming
the
address
section
you can
send
as well a
turnout signal
via your
model railway software
.
The
transmitted data format
(
DCC or Märklin-Motorola
) has to
match
the
data
format
you have selected with the
jumper J4
.
Remarks: It does not matter
which of the
four addresses
from a
group
you will
use for programming
.
If the
DigitalBooster DB-4
understands
the
address
the
DB-4
will
confirm
the
assignment by
flashing the green LED a little faster
.
Following
the
green LED
will
flash slower
again.
