7
WALL MOUNTING PLATE
There are 4 holes in the round wall mounting plate for securing it to a wall. Please note that countersunk screws are required to secure the plate
and ensure that their flat heads are flush with the plate (screws are not included in the packaging content). The wall mounting plate is equipped
with a 4-pole terminal block, sliding contacts and two openings for speaker cables.
1
TERMINAL BLOCK
4-pole terminal block with spring clamping for connecting a speaker cable with an up to 2.5 mm² cross-section and
for sending the amplifier signal to another speaker connected in parallel. Please note the markings directly over
the contacts for the correct polarity. Open the terminal contacts of the terminal block by sliding a small screwdriver
with a flat head into the small opening above the respective contact. Now insert the stripped speaker cable into the
terminal contact and pull the screwdriver out of the opening once again to close the terminal contact.
2
CENTRAL CABLE BUSHING
Central cable bushing for speaker cables installed in a wall. Carefully pull the cable coming from the wall through
the 2mm drill hole present in the rubber sealing. The drill hole in the rubber seal is stretched as a result and
therefore surrounds the cable.
When mounting outdoors: If the rubber sealing is torn when mounting, seal the tears and open points in the rubber
sealing using silicone sealant.
3
SLIDING CONTACTS
When the speaker is correctly connected to the wall mounting plate, the speaker signal coming from the amplifier
is transmitted via the sliding contacts to the speaker.
4
LOWER CABLE BUSHING
Lower cable bushing for speaker cables installed on a wall. In order to release the cable bushing, the sealing cap
made of plastic must be removed prior to attaching the wall mounting plate to a wall.
When mounting outdoors: Seal open points between cable and cable bushing after installation using silicone
sealant.
WALL MOUNTING
The speaker has a wall bracket with a practical lock mechanism. Thanks to the integrated connector panel, the speaker can also be used in visually
demanding environments without visible cables. The 27° tilt and 45° swivel mechanism enables exact positioning for precise sound coverage.
Important safety information:
Overhead mounting requires experience, including the calculation of the limits for the workload, the
installation material used and regular safety tests of all installation materials and speakers. If you are not qualified, do not try to
perform the installation yourself, but use a professional company!
1
Prior to installing the speaker, remove the wall mounting plate from the wall bracket.
To do this, loosen the safety screw
A
in the dome-shaped union nut using the hex key included, turn the union nut counterclockwise from the wall
bracket and pull the wall mounting plate
B
downwards from the wall bracket.
1
2
3
3
4
1
A
B
