- 11 -
−
When the distance cannot be adjusted anymore, the ball throw discs have to be replaced. Therefore
loosen the screws
(Fig.16.)
found in the plastic disc holders – with the smaller allan key found among the
accessories - (regarding all 3 discs), then remove the “adjusting screws” found at the two upper motors (it
is not enough only to loosen those)
(Fig. 17.)
Then totally turn up the two upper motors gripping their
casings and turning those away from the throwing hole in order to make possible the pull down of the
throw discs from the shafts of the motors.
(Fig. 18.)
Then the ball throw disc is pulled off the motor shaft.
(Fig. 19.a,b,)
Take away the plastic discs from the
ball throw foam (it is held together by three screws) and insert those onto the new foam disc. Fix this set
again with the three screws.
Slide the new disc onto the shaft in a way that the end of the shaft to be 0,5-1 mm out
(Fig. 18.),
and tighten
the warm screw. Then adjust the correct distance of the discs with the help of the adjusting tube as it is de-
scribed above.
−
If a
ball jam
should occur, the machine tries automatically to remove the
machine tries automatically to remove the jam by turning the motor and
remove the jam by turning the motor and the throw discs forwards and
motor and the throw discs forwards and backwards (7-8 times). In case the
wards and backwards (7-8 times). In case the feeding motor and the three
times). In case the feeding motor and the three throwing motors jam for
motor and the three throwing motors jam for any reason the machine stops
motors jam for any reason the machine stops in self-defence. Then the
machine stops in self-defence. Then the fault signal is the following: all
Then the fault signal is the following: all the 6 yellow lights start to flash
following: all the 6 yellow lights start to flash on the control box. You
have no other choice than, to take out the head from the machine, and
take out the offending balls from the bottom part of the robot with the
help of a pencil or screwdriver, etc. through the cleaning hole found
there
. (Fig. 20.)
Fig. 16.
Fig. 15.
Fig. 16.
Fig. 19b.
Fig. 19a.
Fig. 20.
Fig. 17.
Fig. 18.
